Electric Motor Control Course Archives - Industrial Instrumentation and Automation

Summary and Key Terms in Engine Braking Systems

♦ The most common methods used to brake three-phase asynchronous motors with short-circuited rotors are: by electric brake, by countercurrent braking, and by DC injection. ♦ For braking

Electric Motor Control Course

Braking due to unbalanced power supply in three-phase motors

The three-phase asynchronous motor is designed to be powered by a balanced three-phase voltage system. This generates a magnetic flux of constant amplitude in the rotating stator.

Electric Motor Control Course

DC injection braking in three-phase motors

This braking procedure is achieved by disconnecting the motor from the AC power supply and connecting two terminals of its stator to a DC power source. These remain valid.

Electric Motor Control Course

Braking of three-phase asynchronous motors with wound rotor: by electrobrake, hypersynchronous and countercurrent

BRAKING OF THREE-PHASE ASYNCHRONOUS MOTORS WITH WOUND ROTORS The same as with short-circuited rotor motors, in many applications of wound rotor motors, it is necessary

Electric Motor Control Course

Countercurrent Braking and DC Injection

BRAKE INCORPORATED IN THE MOTOR In this special type of motor, the rotor, which is short-circuited, is slightly truncated conical and is displaced a little with respect to the stator core,

Electric Motor Control Course

Braking Systems: Three-phase Asynchronous Motors with Short-Circuit Rotor by Electrobrake

GLOSSARY Device An organized set of parts that performs a specific function within an electrical circuit. Control Device Manually operated devices that, included in auxiliary circuits, allow

Electric Motor Control Course

Rotor Start with Resistors

Slip-Ring Motor Starter: Resistor-Based Rotary Start. This type of starter involves installing resistors in the motor's rotor circuit. Unlike other starters

Electric Motor Control Course

Stator Start with Autotransformer

STATOR STARTING WITH AUTOTRANSFORMER This type of starting is used when it is desired to reduce the transient starting and operating current from the network to lower levels

Electric Motor Control Course

Reduced voltage starters: star-delta and stator with resistors

REDUCED VOLTAGE STARTERS STAR-DELTA STARTING This starter can only be applied to motors where the two ends of the three stator windings have outlets on the plate

Electric Motor Control Course

Full Voltage Starters: DAHLANDER CONNECTION and INDEPENDENT WINDINGS

DAHLANDER CONNECTION, 1 DIRECTION OF ROTATION, 2 SPEEDS This type of motor only allows for two speeds (4 and 8 poles, 6 and 12 poles, etc.); it contains 6

See more results...